Polar CS400 Bedienungsanleitung PDF herunterladen (Seite 24)

Select Settings > Features > Altitude > Calibrate > set the altitude of current location

If the altitude of your location differs significantly from the displayed altitude value Calibrate to xx? is

displayed.

Yes: Altitude calibrated to xx is displayed.

No: Altitude calibration canceled is displayed.

Calibrate the altitude to ensure it remains accurate. Set the reference altitude whenever a reliable

reference, such as a peak or a topographic map, is available or when at sea level.

Calibrating the Altitude Automatically

Select Settings > Features > Altitude > AutoCalib > On / Off

By using the altitude Automatic Calibration option, you can adjust the starting elevation to be set

always the same in the beginning of the exercise. Calibrate the elevation manually and turn the

Automatic Calibration (AutoCalib) on. From now on, this elevation will be always used as the base

elevation in the beginning or the exercise, when automatic altitude calibration is in use. Also, if the

Automatic Calibration is turned on and you calibrate the cycling computer manually, this new value

will be used as a new starting elevation for the Automatic Calibration option.

If the elevation or air pressure changes significantly, you are prompted to confirm the change. If you

change the elevation, Altitude calibrated to xx m/ft indicates that calibration has succeeded. If Altitude

calibration failed is displayed, re-calibrate the altitude.

You can also set the elevation for the Automatic Calibration also by using the Polar ProTrainer 5

software. For more information see software help.

Elect this option if you train in the same environment. This way, altitude values are always correct.If the

sport profile of the exercise includes automatic calibration, altitude measurement always begins at this

elevation regardless of the general elevation settings.

Recording Rate

Select Settings > Features > Rec.rate > 1 / 5 / 15 / 60 sec

The cycling computer can store your heart rate, speed, cadence, power and altitude in 1, 5, 15 or 60

second intervals. A longer interval gives you more recording time, while a shorter interval allows you to

record more heart and other data. This enables accurate data analysis using the Polar ProTrainer 5

software.

A shorter recording rate consumes the memory of the cycling computer more rapidly. The remaining

recording time is displayed on the lower row when setting the rate. Default recording rate is 5 seconds.

When less than 30 minutes of maximum recording time is left, the recording rate changes

automatically to longer recording time (1s > 5s > 15s > 60s). This will maximize recording time to

record exercise data. When the session ends, the current recording rate will be used in the next

training session.

The following table shows the maximum recording times for each recording rate. The maximum

recording time can be shorter, if you record a large number of short exercises.

Recording rate will change when less than 30 minutes of recording time is left. Memory low is displayed 60

minutes before the memory runs out.

Recording Rates for Speed and Cadence

Speed

Cadence Rec Rate 1s Rec Rate 5s Rec Rate 15s Rec Rate 60s

Off

Off 10h 30min 52h 40min 158h 633h

Off

On 7h 50 min 39h 30min 118h 474h

Polar CS400 User Manual 24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 46 47

Kommentare zu diesen Handbüchern

Keine Kommentare

Polar CS400 Bedienungsanleitung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gesundheit und Hygiene Polar CS400